I am using a Windows 10 64-bit laptop with USB 3 ports and have installed the STLINK utility, enstsw-link004.zip, which includes the relevent USB drivers. The installation appears to succeed, however, when I plug in the development board via USB Windows complains with 'USB device not recognised'. Sigmakey Box Dongle Latest Version V2.38.05 Crack Setup With Drivers Free Download August 19, 2020 MRT Key Dongle Latest Version V3.59 Full Cracked Setup Free Download. Anthophobia game. JR programmer v2 device-JRPv2 to nand header wires (cable that goes from the JRP to the 360's motherboard)-JRPv2 to CR programming cable. (cable that goes from the JRP to glitch chips in order to program them)-6 pin bit of pin header so you can insert into the JRP to CR programming cable to easily program glitch chips without soldering.
WiFi JLR DoIP VCI is compatible with original SDD and Pathfinder software. But it uses it own driver. Here you can download software and driver for doip vci for free.
Note: The follow software and driver is for DoIP VCI clone (Item No. SP312).
Support Pathfinder for JLR 2017 up Support SDD for JLR -2016 Support SDD online programming Support Pathfinder online key programming Support SDD engineering software Support Pathfinder engineer software Support EXML edit Support VBF edit
Please pay more attention to the version of the DoIP VCI driver. It should always be the latest version. So you should update the driver without delay.
The above driver 19.04.28 driver is the current version (Aug. 2019). If newer version driver released, you can download latest version on official website as well (check picture below).
Jr Programmer V2 Download
The connection of DOIP VCI
Connect with USB; (It’s easy)
Connect with WIFI; (You can choose the Wifi named “DoIP-VCI-11D4”, and the last four numbers are in random.)
The Connection between the DoIP VCI and computer
Following the picture below, open the VCI Manager and click the “connect”
Check the connection status with the computer.
When it shows a green check mark, VCI is detected
Update of DoIP VCI’ firmware.
Open“VCI manager”
Then click the “VCI Update”
Click the “Start” and you can check the update progress on the right
Attention:
When you click the “start”, vci cannot be interrupted or stopped. Otherwise the JLR DoIP VCI will be damaged. You can disconnect when it finished.
( If you have Pathfinder account you can login directly. You can contact JLR VCI factory engineer for help if you don’t have an account. Email: [email protected])
It doesn’t connect successfully if it shows “SIM”“SimFiles”, you should select the communication interface as “JLR-JLR-DoIP, D-PDU API by Bosch” and VCI serial“86004905”. Now you can use it for diagnosis.